Document Actions
Foredeck and rear tank all together
Almost ready to take out of the mould.
Final finishing before popping out of the mould. All the main structures are added before removing the hull from the mould. This has several advantages: the hull shell stays rigid so the template precut panels fit perfectly, the outside ends of the wing tubes can be hot glued to the mould and the reference points are all readily available.
The foredeck and needs a curved slit cut for the selftacker mounting to pass through.
Rear tank with top glued on.
Hull with wings attached just prior to removing from mould
Carbon outer skin
Side view of Hydrofoils
Top view of Hydrofoils
L3 hydrofoils underway!
Modified L3 with rear-side view of hydrofoils
Modified L3 with side view of hydrofoils
Modified L3 with front view of hydrofoils
Hydrofoils
L4 underside
L4 tow test
L4 side view rendering
L4 front full view rendering
L4 front-quarter view rendering
L4 Mould
L4 foredeck
Vacuuming Foils - Close up
Vacuuming Foils
Foils - foam filled
Davie Norris Boatbuilders Limited
